WARNING: Do not attempt chain repairs. If there is
a problem with the chain, have a bicycle service shop make
any repairs.
The chain must be at the correct tightness. If too tight, the
bicycle will be difficult to pedal. If too loose, the chain can
come off the sprockets.
When the chain is at the correct tightness, you can rotate
the crank freely and you can pull it no more than one-half
inch away from a straightedge as shown.
Adjust the tightness of the chain as follows:
• Loosen the axle nuts of the rear wheel.
• Move the rear wheel forward or backward as necessary.
NOTE: Make sure the rear wheel is in the center of the
LUBRICATION
WARNING: Do not over lubricate. If oil gets on the wheel rims or the brake shoes, it will reduce brake
performance and a longer distance to stop the bicycle will be necessary. Injury to the rider or to others can occur.
• The chain can throw excess oil onto the wheel rim. Wipe excess oil off the chain.
• Keep all oil off the surfaces of the pedals where your feet rest.
• Using soap and hot water, wash all oil off the wheel rims, the brake shoes, the pedals, and the tires.
• Rinse with clean water and dry completely before you ride the bicycle.
• Use only a bicycle specific lube, as other common oils will not provide the correct lubrication.
Frequency Component Lubricant How to Lubricate
Weekly Chain Chain lube or light oil Brush on or squirt
Derailleur Wheels Chain lube or light oil Oil can
Derailleurs Oil 3 drops from oil can
Brake Calipers Oil 2 drops from oil can
Every Six Months Freewheel Oil 2 squirts from oil can
Brake Cables Lithium based grease Disassemble
Yearly Bottom Bracket Lithium based grease Disassemble
Headset Lithium based grease Disassemble
Hubs (front and rear) Lithium based grease Disassemble
35
E
To Next Page
Loading...
