7
USING THE CHARGER
The charger should be examined regularly for damage to the cord, plug, enclosure and
other parts. In the event such damage has occurred, the off-road electric scooter should
not be charged until the charger has been repaired by qualified personnel or replaced.
Use only the supplied, recommended charger. Always use caution when charging.
The charger is not a toy and should be operated by an adult.
Never operate the charger near flammable materials or liquids, and operate the
charger in well-ventilated areas.
Disconnect the charger and unplug it from the off-road electric scooter when not in
use. Do not exceed the recommended charging time.
Always disconnect the charger from the off-road electric scooter prior to wiping
down or cleaning the off-road electric scooter with any liquid.
FAILURE TO HEED THE WARNINGS LISTED ABOVE INCREASES RISK OF POTEN-
TIALLY SERIOUS INJURY. USE THE APPROPRIATE CAUTION WHEN RIDING AND
ALWAYS WEAR PROTECTIVE GEAR.
BEFORE YOU BEGIN ASSEMBLY
Remove contents from box. Inspect the contents of the box for scratches in the paint,
dents or kinked cables that may have occurred during shipping.
WARNING:
Make sure that the key power switch is turned “OFF” before assembling or
conducting any maintenance on the off-road electric scooter.
ESTIMATED ASSEMBLY TIME
Assembly by adult with mechanical experience recommended. You should allow
approximately 20-25 minutes for assembly, not including initial charging time. Initial
charging can take approximately 18 hours (see page 11 for charging information)
Required tools
· 5mm Allen key (included)
· 8mm, 10mm, 12mm, 13mm and 17mm wrench (not included)
· Phillips screw driver (not included)
· Bicycle tire pump for Schrader valve tires with pressure gauge (not included)
To Next Page
Loading...
Need help?
General
