9
Scooter Body and Front Fork Assembly
Tools Required: 13mm wrench & 17mm wrench (not included)
1 Insert the stem (assembled with the front
fork, front wheel and the steerer tube already)
into the scooter body as shown.
Note: Make sure the cable wires are smooth
and out of the way before inserting (to avoid
kinks or breakage)
2 Align the holes A & B, and insert
a bolt (M10x120m) into each and
securely tighten the bolts with
13mm and 17mm wrench from the
left and right sides at the same
time.
ASSEMBLY
To Next Page
Loading...
Need help?
General
