Dynamic DX Power Module PMB - Page 66

'LDJQRVWLFVDQG)DXOW)LQGLQJ
61
/LPS0RGH
If the DX System detects some faults, it will revert to Limp Mode. This is a
reduced speed mode which recognises problems, but allows the wheelchair user to
limp home, where the problem can be assessed.
Warning : If the DX System is displaying a fault and the chair enters Limp
Mode, do not operate except to reach a safe environment. Proceed with caution as
the chair performance may be significantly altered. Have the chair serviced by a
Service Agent.