29
pulling the male connection from the female connection. Reconnect to
make sure the
connection is snug and tight. Leave the control panel hanging from the
wall panel (do not replace with the wood frame as of yet).
4. Next, you can plug the sauna room back into the wall outlet or turn the
breaker back “ON”. Test the control panel to see if it is responding and
working properly or if the "-L" is still displayed. If the control panel is
responding and working properly, then it was a connection issue causing
the problem and you can put back the control panel and wood frame.
Solution: Unfortunately, our saunas cannot be connected to a GFCI due
to the amount of power the sauna uses. We have had customers who
have connected their sauna to a GFCI protected outlet for the first time or
for many months and then all of a sudden the GFCI starts causing the
sauna to trip or just not turn ON at all. We do not have an answer as to
why the GFCI was fine in the beginning when supplying power to the
sauna and then suddenly starts causing problems for the sauna power
supply. We recommended not connecting the sauna power cord to a GFCI
protected outlet.
5. Wall Outlet Melting
Solution: A common problem with wall outlets is loose wiring on the
connection points of the terminals of the receptacle. A loose wire will also
make for a bad connection and cause an unusual amount of heat buildup.
Loose connections can also cause sparking in the junction box that can
result in arcing. You'll likely see burn marks around the terminals if this
happens. You will need to consult with an electrician to replace the wall
outlet. You will need to contact Customer Service if the power supply cord
is damaged as the power supply will need to be replaced.
6. Bluetooth
Solution: Please note that you can only have a single device connected
to the Bluetooth at any given time. You must unpair your device before
connecting with another device. To do a master reset of the Bluetooth, you
will need to unplug the sauna power cord from the wall outlet for 15
minutes.
7. Speaker Noise
Solution: If you are hearing a humming noise from either speaker or both
speakers while the Bluetooth feature is connected with your musical
device, then there may be an issue with the control panel(s). To confirm
this, please connect your musical device using the MP3 AUX wire that
came with the sauna room to connect your musical device to the sauna
speaker system. You will connect one end of the MP3 AUX wire to your
To Next Page
Loading...