“compression” point. Return the handle to its original position
and pull swiftly. Do not pull out the rope all the way. After
starting the engine, allow the starter handle to return to its original
position while still holding the handle. (See Fig 3-5)
（ 5 ） After starting the engine,
gradually open choke by
turning the choke lever and
finally keep it fully opened.
Do not fully open the choke lever immediately when the engine is
cold or the ambient temperature is low, because the engine may
stop.
FLOAT Type (See Fig 3-6-B)
DIAPHRAGM Type (See Fig 3-6-B)
① CLOSE ② OPEN
To Next Page
Loading...