SETING ENGINE SPEED
（1）After the engine starts, set the speed control lever at MIN(low
speed) position and warm it up without load for a few minutes.
（2）Gradually move the speed control lever toward MAX(high speed)
position and set it
at the required engine speed.
■ Whenever high speed operation is not required, slow the engine down
(idle) by moving the speed control lever toward MIN (low speed)
position to save fuel and extend engine life.
1、Position the throttle lever for the desired engine speed.
NOTICE！ When starting the machine, do not exceed 1/3 throttle
position. A higher setting may be cause the centrifugal clutch to engage
and the handle to rotate.
2、Through the handle guiding cause the machine to travel. The machine
has the high compaction performance when the metal sheet balances on
the surface. Never severity pressure or holding on the handle can
damage the machine. See down fig.
To Next Page
Loading...