15
The gas hot water pressure washer is designed and built as 2 independent systems (heating
and pressurizing)
If you need hot water only. Inlet connection for pump can be disassembled in the screw
connection and you can easily connect your garden hose to the water outlet of the heater and
thereby use your hot water heater.
5. Applications and methods
5.1 Techniques
• Efficient high pressure cleaning is achieved by following a few guidelines, combined with
your own personal experience of specific cleaning tasks. Accessories and detergents,
when correctly chosen, can increase the efficiency of your pressure washer. Here is
some basic information about cleaning.
5.1.2 Vehicles
Vehicle
bodywork
• Standard lance
• Detergent for
vehicles
• Curved brushes
and under chassis
washes
1.
Apply detergent to vehicle or equipment surface in
order to soften up dirt and grime. Apply from
bottom to top. In case of particularly dirty vehicles,
pre-spray with a product such as Allosil in order to
remove traces and insects etc. the rinse at low
pressure and apply normal car cleaning detergent.
Let the detergent settle for 5 minutes before
cleaning off. Metallic surfaces can be cleaning using
Rim Top.
2. Proceed with cleaning using the high pressure lance.
Clean again from bottom to top. Use brushes in
order to add mechanical cleaning effect. Curved
lances or undercarriage washers can be valuable for
the cleaning of the car under chassis.
3. Clean fragile areas such as motors, rubber at lower
pressure and temperature to avoid damage.
4. Apply liquid wax using your pressure washer in order
to protect the body work from pollution.
General
surfaces
metallic
equipment
• Foam nozzle
• Standard lance
• Curved lance
Apply foam on the surface to be cleaned. Apply on dry
surfaces. Apply from top to bottom on vertical surfaces. Let
the foam act for up to 30 minutes for optimal effect. Proceed
with cleaning using the high pressure lance. Use applicable
accessories. Use high pressure to dislodge large amounts of
incrusted dirt or grime. Use lower pressure and high water
volume in order to rapidly flush away loose dirt and rinse
surfaces. Areas covered by amounts of loose dirt, such as
animal remains in slaughter houses, can be removed by
using high water flow to flush away the dirt to evacuation
pits or drains tank.
To Next Page
Loading...