Dynapac CC142C - Before Starting Procedures; Battery Disconnecter and Hourmeter; Sprinkler System Preparation

13CC102/C/122/C/132/142/C M102EN4
Dismantle the clogged nozzle by hand. Blow the nozzle
(2) and fine filter (4) clean with compressed air, or
install replacement parts, and clean the clogged parts
at a later opportunity.
Wear protective goggles when working
with compressed air.
Fig. 10 Pump system
1. Water filter
2. Stopcock
3. Water pump
3
Fig. 9 Nozzle
1.Sleeve
2.Nozzle
3.Compaction
4.Strainer
1
2
3
4
When cleaning the coarse filter (1), close the stopcock
(2) and loosen the filter housing.
Clean the filter and filter housing, ensure that the rubber
gasket in the filter housing is intact.
After inspection and any cleaning, start the system and
check that it works.
A drain cock is located in the left part of the pump
system area. This facilitates draining of both tank and
pump system.
1
2
Sprinkler system/Drum
Checking – Cleaning
Start the sprinkler system and make sure that no
nozzle (1) is clogged. If necessary, clean clogged
nozzles and the coarse filter located adjacent to the
water pump, see figures below.
1
Fig. 8 Drum
1. Nozzle
EVERY 10 HOURS OF OPERATION (Daily)