To Next PageTo Next Page
Need help?Do you have a question about the Dynapac CC1300C and is the answer not in the manual?
General| Brand | Dynapac |
|---|---|
| Model | CC1300C |
| Category | Construction Equipment |
| Language | English |
Description and intended use of the CC1300C roller.
General safety guidelines, warnings, and CE marking.
Basic rules for operating and maintaining the machine.
Essential safety rules for operating the roller.
Procedures for safe driving and environmental care.
Precautions for operating near edges and on slopes.
Guidance on lubricants, temperatures, and cleaning.
Measured vibration, noise, and slope limitations.
Physical size, weight, and volume specifications.
Engine, speed, climbing capacity, and tire specifications.
Electrical system, bolt torques, and hydraulic pressures.
Engine, electrical, propulsion, brake, steering, ROPS.
PIN, serial numbers, and data plates.
Location and meaning of decals, symbols, and control panel.
Master switch, seat adjustment, instrument checks.
System interlocks, brake checks, and vibration modes.
Engine start, warm-up, and roller operation.
Procedures for stopping and securing the machine.
Procedures for parking for extended periods.
How to lift, tow, and secure the machine.
Rationale for maintenance and warranty terms.
Guide to fluids and maintenance symbols.
Comprehensive checklist for various service intervals.
Tasks every 10 hours, including cooler cleaning.
Air filter indicator, backup filter, and cleaning.
Greasing steering components and checking tire pressure.
Verifying the operation of the brakes.
Indicator, main filter replacement, and cleaning.
Lubrication and tire pressure checks.
Inspecting the battery's condition.
Procedure for changing engine oil and filter.
Inspecting the battery's condition.
Procedure for changing engine oil and filter.
Inspecting drum oil, rubber elements, and reservoir cap.
Lubricating control mechanisms.
Inspecting the battery's condition.
Procedure for changing engine oil and filter.
Inspecting drum oil, rubber elements, and reservoir cap.
Replacing hydraulic filter and draining reservoir.
Replacing fuel filter and pre-filter.
Inspecting the battery's condition.
Procedure for changing engine oil and filter.
Inspecting drum oil, rubber elements, and reservoir cap.
Replacing hydraulic filter and draining reservoir.
Procedures for fuel, pre-filter, water pump, and tanks.
