Operation
4812161201_F.pdf 2018-04-17
6
9
Fig. Instrument panel
6. Parking brake
9. Brake warning lamp
Parking brake - Check
Make sure that the parking brake (6) is activated.
The roller can start to roll when the engine is
started on sloping ground, if the parking brake is
not applied.
Make sure that the parking brake (6) is activated.
The roller can start to roll when the engine is
started on sloping ground, if the parking brake is
not applied.
Operator position
1
2
3
4
Fig. Driver seat
1. Seat belt
2. Safety rails
3. Rubber element
4. Anti-slip
If a ROPS (Roll Over Protective Structure) is fitted to
the roller, always wear the seat belt (1) and wear a
protective helmet.
Always replace the seat belt (1) if it shows signs of
wear or has been subjected to excessive strain.
Always replace the seat belt (1) if it shows signs of
wear or has been subjected to excessive strain.
Check that the platform's rubber elements (3) are
in good condition. If the elements are worn this
will have a negative effect on comfort.
Check that the platform's rubber elements (3) are
in good condition. If the elements are worn this
will have a negative effect on comfort.
Ensure that the anti-slip (4) on the platform is in
good condition. Replace where anti-slip friction is
poor.
Ensure that the anti-slip (4) on the platform is in
good condition. Replace where anti-slip friction is
poor.
38
To Next Page
Loading...
Need help?
General
