Maintenance, 10h
4812161201_F.pdf 2018-04-17
Sprinkler system/Drum
Checking - Cleaning
Fig. Drum
1. Nozzle
1
Start the sprinkler system and make sure that no
nozzles (1) are clogged. If necessary, clean clogged
nozzles and the coarse filter located by the water
pump; see figures below.
The sprinkler system
should be drained if there
is a risk of freezing.
The sprinkler system
should be drained if there
is a risk of freezing.
Sprinkler system / Wheels
Check - Cleaning
1
2
Fig. Wheel rack
1. Filler cap
2. Nozzle (one for each tire)
Fill the rear tank with emulsion fluid; for example,
water mixed with 2% cutting fluid. Make sure that the
sprinkler nozzles (2) are not clogged. Clean them and
the filter if necessary. See under Sprinkler
system/Drum; Check - Cleaning, for detailed
instructions.
Check the tire treads now and then to see if any
asphalt compound has stuck. This can occur
before the tires are sufficiently warm.
Check the tire treads now and then to see if any
asphalt compound has stuck. This can occur
before the tires are sufficiently warm.
Fluids that are flammable or detrimental to the
environment must not be used in the emulsion
tank.
Fluids that are flammable or detrimental to the
environment must not be used in the emulsion
tank.
76
To Next Page
Loading...
