Operation
4812161201_F.pdf2018-04-17
Operation
Before starting
Master switch - Switching on
2
1
Fig. Engine compartment
1. Battery disconnector
2. Power socket, 12 V
Remember to carry out daily maintenance. See the
maintenance instructions.
The battery disconnector is on the left side in the
engine compartment.
Turn the key (1) to switched on position. The roller is
now supplied with power.
The engine hood must be unlocked during
operation, unless the battery disconnector is freely
accessible from the outside, so that the battery
voltage can be quickly disconnected if necessary.
The engine hood must be unlocked during
operation, unless the battery disconnector is freely
accessible from the outside, so that the battery
voltage can be quickly disconnected if necessary.
1 23
Fig. Driver seat
1. Handle - Length adjustment
2. Handle - Backrest angle
3. Handle - Weight adjustment
Driver seat (Std) - Adjustment
Adjust the operator’s seat so that the position is
comfortable and so that the controls are within easy
reach.
The seat can be adjusted as follows.
- Length adjustment (1)
- Backrest adjustment (2)
- Weight adjustment (3)
Always check that the seat is in locked position
before starting.
Always check that the seat is in locked position
before starting.
35
To Next Page
Loading...
