Dynapac CC142C - Parking the Roller; Chocking the Drum for Parking; Securing with Battery Disconnecter

21CC102/C/122/C/132/142/C M102EN4
Unscrew and ensure that the reservoir cap is not
clogged; air must have unobstructed passage through
the cap in both directions.
If clogged in either direction, clean with a little diesel oil
and blow with compressed air until free passage is
assured, or replace the cap with a new one.
Wear protective goggles when working
with compressed air.
1
2
Fig. 31 Operator’s station
1.Forward/reverse lever
2.Fastening screws
Lubricate the forward/reverse controls in the engine
compartment with a few drops of oil.
If the controls become sluggish after a long period of
use, remove the cover and the forward/reverse lever in
the operator’s station and lubricate the mechanism.
Lubricate the forward/reverse mechanism.
Unscrew the screws (2) in the top of the protective
cover (1), remove the cover and lubricate the
mechanism under the cover with oil.
Controls – Lubrication
Controls – Lubrication
1
Fig. 30 Engine compartment
1. Forward/reverse lever
EVERY 500 HOURS OF OPERATION (Every three months)
1
Hydraulic reservoir cap
– Check
Fig. 29 Engine compartment
1. Tank cap