To Next PageTo Next Page
Need help?Do you have a question about the Dynapac LG200 and is the answer not in the manual?
General| Brand | Dynapac |
|---|---|
| Model | LG200 |
| Category | Power Tool |
| Language | English |
Provides critical safety guidelines for handling petrol and diesel fuel, including avoiding ignition sources.
Stresses the importance of regular hydraulic system maintenance and replacing hoses due to deterioration.
Lists essential safety equipment for operators and nearby personnel, including helmet, goggles, and gloves.
Instructs users to read the manual, check handles, and ensure all safety devices are secured before starting.
Warns about sulfuric acid in batteries and the risk of explosive gases, advising protective measures.
Outlines mandatory safety practices, including using original parts and keeping stickers legible.
Highlights operational safety, including keeping feet clear and avoiding poorly ventilated spaces due to carbon monoxide risk.
Instructs to keep at least two-thirds of the plate on firm ground when operating near an edge.
Warns about reduced maneuverability on wet/loose ground and advises caution on slopes and uneven terrain.
Recommends driving up/down slopes, avoiding driving across, and notes maximum tilt limits.
Provides net and operating weight details for LG200 (Honda, Hatz, Hatz El.) models.
Details vibration frequency, centrifugal force, and amplitude for LG200 models.
Lists speed of travel and maximum tilt angle for LG200 models.
Specifies fuel tank, crank case, hydraulic fluid, and eccentric element oil volumes for LG200.
Details engine models (Honda GX200, Hatz 1B20) and output/speed for LG200 models.
Presents noise levels and hand-arm vibration values for LG200 models.
Provides dimensional data (A-G) in mm and inches for LG140, LG160, and LG200 models.
Details the steps for starting Honda GX engines, including throttle, choke, and start button operation.
Lists pre-operation checks for Hatz engines, including fuel and oil levels.
Explains how to stop Hatz engines using the ignition switch and removing the key.
