7
Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | info@dynaset.com | www.dynaset.com
HIGH PRESSURE WATER PUMPS
GENERAL
1. GENERAL
This manual contains general information about assembly, installation, operation
and maintenance of DYNASET HPW high pressure water pumps.
ATTENTION!
Read this user manual before installation, use or maintenance of the HPW
pump to ensure proper handling, operation and maintenance right from
the beginning. Pay attention to warnings and safety instructions. READ
CHAPTER ”2. SAFETY” for more information.
1.1. PRODUCT INFORMATION
DYNASET HPW pump converts the hydraulic oil flow of a base machine into high
pressure water. HPW pumps are used for pumping water and other fluids depend-
ing on a model. The power of the pump is defined by flow rate and pressure. Actu-
ating power is supplied from the hydraulic system of the base machine or other
hydraulic installation. Pumping fluid can be taken from reservoir or pressurized
supply network. Water can also be taken form natural source such as lake or river.
The relation ship between hydraulic oil flow and pressure to pumping fluid flow
and pressure is linear. HPW pumps can be safely operated in power range of
0-100%.
Most of HPW pumps are self-priming. READ CHAPTER „10. TECHNICAL SPECIFICA-
TIONS“ for specific characteristics of any pump.
NOTE!
The design of HPW pump is protected with an international patent.
To Next Page
Loading...
