Dynatronics dynatron solaris 709 plus

To Next Page

To Previous Page

CAN/CSA WAVEFORM REQUIREMENTS

DYNATRON SOLARIS

PLUS SERIES | SERVICE MANUAL REV. 6 | AUGUST 29, 2017 141

Hi Volt

Mid-Range Full Range

500 ohm Load 200 ohm Load 1000 ohm Load

2000 ohm Load

Main Page

Indications for Use2
Introduction to the Dynatron Solaris® Plus Series9
Simplified Setup10
Language Selection11
Installation and Features12
Standard Components13
Optional Accessories14
Dynatron Solaris® Plus Physical Features15
Channels and Jacks21
Current Limit23
Error Messages24
Ultrasound Error Messages25
Testing Leads26
Carbon Electrodes27
Self-Adhesive Electrodes28
Electrotherapy Information and Usage Cautions30
Interferential / Premodulated Instructions34
Detailed Interferential / Premodulated Setup35
Interferential and Premodulated Modality Information39
Premodulated (Bipolar) Therapy40
Target Sweep41
Biphasic / Russian Instructions42
Biphasic / Russian Quick Setup43
Detailed Biphasic / Russian Setup44
Biphasic / Russian Modality Information47
High Volt Instructions50
High Volt Probe Treatment Setup51
Detailed High Volt Setup52
Default Setting53
High Volt Modality Information56
High Volt Default Settings57
Microcurrent Instructions58
Detailed Microcurrent Setup60
Microcurrent Modality Information63
Microcurrent Default Settings64
Direct Current Instructions66
Detailed Direct Current Setup67
Direct Current Modality Information69
Direct Current Warnings70
Dynatron Tri-Wave™ Operating Instructions71
Detailed Treatment Setup73
Dynatron Tri-Wave™ Light Modality Information78
Ultrasound Instructions80
Soundhead Warming81
Head Temperature Hot Display82
Detailed Ultrasound Setup83
Ultrasound Modality Information86
Penetration of Ultrasound Waves87
Types of Delivery88
Frequency of Treatment89
Soundhead Optimization Adding or Replacing Soundheads91
Ultrasound Calibration93
Ultrasound Problem Solving94
Miscellaneous95
Ultrasound Beam Profiles97
Combination Therapy Instructions99
Stim through the Soundhead100
Combination Therapy Setup101
Modify a Treatment102
Dynatron® Thermostim™ Probe103
Thermostim Probe Detailed Setup104
Using Stim with the Thermostim Probe Premod Treatments Setup108
Simultaneous Treatments110
Modify Simultaneous Treatments111
Contraindications, Warnings, & Precautions112
Warnings113
Treatment Setup Warnings114
Adverse Effects115
Contraindications, Warnings, & Precautions for Microcurrent116
Precautions117
Contraindications, Warnings, & Precautions for Ultrasound Treatment118
Precautions119
Warnings120
Contraindications, Warnings, & Precautions for Tri-Wave Light Treatments121
Precautions and Warnings122
Dynatron Solaris® Plus Descriptions and Diagrams124
Hardware Configurations125
Processor Interaction126
Processor Interaction with the Output Jacks127
General Specifications128
Safety Features of the Dynatron Solaris129
Suggested Maintenance Schedule130
Software Updates132
Routine Ultrasound Calibration Inspections for Solaris Plus133
Definition of Symbols and Labeling134
Equipment Classification135
Technical Summary136
Restore Factory Defaults137
Basic Troubleshooting Techniques138
Testing Carbon Pads139
Ultrasound Calibration Procedure140
Battery Operation142
Battery Requirements143
CAN/CSA Waveform Requirements144
Electromagnetic Emissions and Immunity150
Final Quality Check (QC) Checkoff Sheet154
Dynatron Solaris ® Plus Limited Warranty158

Dynatronics dynatron solaris 709 plus - Page 149

Table of Contents

Related product manuals