not mean that you can play with 200W continuously and expect clear sound and that
the speaker can withstand the load. The greatest danger to a loudspeaker is distor-
ted signal. The amplier provides a distorted signal when it is not able to play louder
without distortion; it is thus easier to damage the speakers with a weak amplier than
with a powerful amplier.
Caution!
If you hear distortion (it sounds bad) when you raise the volume, it is usually an
indication that the amplier cannot handle the required power output. You should
immediately lower the volume. To use the mode “loudness”, or increase the bass or
treble gives a greater risk of distortion. Therefore, you need to be careful when using
these adjustments.
Dynavoice Subwoofers
1. Unpacking and maintenance
We recommend you to unpack your subwoofer with care. After unpacking your pur-
chased Dynavoice product, we suggest you retain all packaging material for possible
future transports.
1.1 Break-in
The subwoofer is brand new and has never been used (except for control testing in
the factory). As with all high-quality loudspeaker systems, the musical performance
of your Dynavoice subwoofer will improve over an initial break-in period. The sub-
woofer needs to be used for a period of about 10-15 hours as an initial break-in
period. This softens the suspension and the subwoofer gets a deeper, rmer and
more dened bass. Attention! Do not play on high volume during the break-in
period.
2. Room positioning
Our subwoofers are designed to t anywhere in your listening room. We recommend
placing the subwoofer between your front speakers. Subwoofer with bass reex ports
located on the back of the subwoofer should have at least the same distance to the
wall as the diameter of the bass reex tube. If you place the subwoofer in a corner,
you can usually obtain more bass.
3
To Next Page
Loading...
