SkyView HDX - Airplane Flight Manual Supplement, Rev Q, 11/5/2021
Accepted by
Seattle AIR-715
on 7/20/2018
Accepted by
Seattle AIR-715
on 10/11/2018
Added knob modules and updated operating limitation.
• Added 6-cylinder EGT/CHT, Flaps and Landing Gear functionality,
• Revised illustrations,
• Moved Airplane Limitations to section 8, and Emergency Procedures to Section
9,
• Revised format of Emergency Procedure checklist,
• Deleted the appendix.
• Revised limitations section for new models
• Added autopilot slip, trim, slip/trim, airspeed high/low message.
• Added autopilot VNAV engagement caution.
• Formatted emergency procedures for improved clarity.
• Added autopilot servo jam emergency procedure.
• Clarified language on FAA approval signature page.
• Formatted section 5.5 (Autopilot Operation) for improved clarity.
• Changed section 3.6 to reference "14 CFR 23.1545" instead of "FAR 23.1545".
• Changed wording in section 5.5 to read "pull" instead of "turn off" with reference
to circuit breakers.
• Updated Figure 18
Accepted by
Seattle AIR-715
on 7/2/2019
• Changed name of document to "SkyView HDX Airplane Flight Manual
Supplement".
• Added note regarding use of this document as an SAFM.
• Applied new document template.
• Added information in Section 3.7, 3.10, 3.11 for twin engine airplanes / Dual
EMS.
• Added Section 4.5: Temperature Indicators.
• Added Section 4.6: Synchroscope.
• Added Section 6.4.2: Trim Messages.
• Added Section 6.4.3: Slip Trim Messages.
• Revision to Section 6.9: Yaw Damper behavior.
• Added Section 9.6.4: Piper Aircraft PA-34 Seneca.