22
Washing and drying the filters
Pre-motor filter
Wash the pre-motor filter at least every month according
to the instructions below to maintain performance.
Press the cyclone release button
and remove the cyclone unit.
Pull out the pre filter.
Wash the filter with cold water only.
No hot water and no detergents.
Shake the filter to remove
debris and excess water.
Repeat the wash/shake cycle
until the water runs clear.
Allow to completely dry naturally
(24 hours minimum).
To refit, re-assemble in reverse order.
1 2 3
24
hrs
To Next Page
Loading...
