Dyson AB10 - Pre-Installation Requirements; Environmental Conditions; Electrical Supply Specifications; Water Supply and Control

Dyson Airblade Tap hand dryer
Points to consider before installation.
Sink compatibility guide.
AB09 pre installation overview.
AB10 pre installation overview.
AB11 pre installation overview.
Points to consider before installation.
Environment
Indoors only.
Dry environment.
Below 2000 metres.
Electrical supply
Correct power available to the appliance
(HV 200-253 V 1600 watt/LV 110-127 V 1400 watt).
A means for all-pole disconnection must be
incorporated into fixed wiring, in accordance
with local wiring regulations.
Water supply
Water pressure between 1-8 bar.
1x ½" BSP pipe feed required.
Water temperature controller required
(thermostatic mixer/water heater).
Water isolation valve required
for ease of install/service.
Location of motor bucket
AB09 / AB10 – Room under sink for motor to be
mounted to surface (266 mm x 142 mm x 189 mm).
Allow for a minimum of 100 mm distance
between the floor and the motor bucket.
AB11 – Metal enclosure (supplied with appliance)
to be fitted behind wall (minimum depth 200 mm).
38 39