Inside the Dyson
Airblade Tap hand dryer
10 11
Airblade™ technology
Air travelling at 690 km/h exits
laser-cut apertures measuring
just 0.8 mm in width.
Aerator
The optional adaptor will reduce
the flow from 3.5 litres per minute
to 1.9 litres per minute. This helps
to reduce water consumption
and decrease your water bill.
Intelligent water and
air infrared sensors
Sensors auto-calibrate so that
air and water are only activated
when a hand is underneath.
Removable end cap
Designed for ease of service.
Laser welding
Fully-automated robotic precision
cutting and welding allows high
quality stainless steel tubes to
be used in construction.
Mains water inlet
Electronic, sensor-controlled
water valve activates
when a hand is detected.
This starts the water flow.
Spring-mounted motor
Motor is mounted using springs
to reduce sound and vibration.
Dyson digital motor V4
Spins at 90,000 rpm, generating
enough power to draw up to
35 litres of air per second
through a HEPA filter.
HEPA filter
HEPA filter captures 99.9% of
particles the size of bacteria and
viruses from the washroom air.
Dirty air in
HEPA filter
Filtered air out
Dyson Airblade Tap hand dryer
Easy to service motor unit
Designed for safe and quick
replacement without the need
for a technician.
To Next Page
Loading...
Need help?
General