Dyson AM07 - Operating the Dyson Appliance; Remote Control Operation; Airflow and Timer Settings; Cleaning and Maintenance

4
Controls
To operate, point the
remote control toward
the front of the base.
Select a high flow of air.
Select a low flow of air.
To clean, wipe with a
dry or damp cloth.
Do not use detergents
or polishes to clean the
appliance.
Look for blockages in
the air inlet holes.
Use a soft brush to
remove debris.
Look for blockages in the
small aperture inside the
loop amplifier. Use a soft
brush to remove debris.
Attach the remote
control to the top of
the appliance with the
buttons facing down.
To set the sleep timer, select the desired time.
When time reaches zero, the appliance will
go into standby mode. To cancel, increase the
time until two dashes appear.
Standby ON/OFF
Standby
ON/OFF
Oscillation
ON/OFF
Airflow control Sleep timer
Clearing blockagesCleaning
4