EasyManua.ls Logo

Dyson DC 59 - Charging and Storing; Battery Safety Instructions; Diagnostics

Dyson DC 59
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
CHARGING AND STORING
This machine will switch ‘OFF’ if the battery temperature is below
37.4°F (3°C). This is designed to protect the motor and battery. Do not
charge the machine and then move it to an area with a temperature
below 37.F (3°C) for storage purposes.
To help prolong battery life, avoid recharging immediately after a full
discharge. Allow to cool for a few minutes.
Avoid using the machine with the battery flush to a surface. This will
help it run cooler and prolong battery run time and life.
DIAGNOSTICS - MAIN BODY
When in use, trigger pressed:
DIAGNOSTICS – BATTERY
When in use, trigger pressed:
When charging battery:
BATTERY SAFETY INSTRUCTIONS
If the battery needs replacing please contact the Dyson Helpline.
Use only Dyson chargers for charging this Dyson machine.
The battery is a sealed unit and under normal circumstances poses no
safety concerns. In the unlikely event that liquid leaks from the battery
do not touch the liquid and observe the following precautions:
Skin contact – can cause irritation. Wash with soap and water.
Inhalation – can cause respiratory irritation. Expose to fresh air and
seek medical advice.
Eye contact – can cause irritation. Immediately flush eyes
thoroughly with water for at least 15minutes. Seek medical
attention.
Disposal – wear gloves to handle the battery and dispose of
immediately, following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical
burn if mistreated. Do not disassemble, short contacts, heat above
140°F (60°C), or incinerate. Keep away from children. Do not
disassemble and do not dispose of in fire.
Solid blue: 'ON'.
Flashing blue: No power, charge battery.
Flashing amber: No power, temporary fault
(e.g. too hot/cold).
Flashing red: Fault (contact Dyson Helpline).
Solid amber: Fault, if persists contact
Dyson Helpline.
Lights off: Charging complete.
Flashing red: Fault (contact Dyson Helpline).
Solid blue: Charging.
Solid amber: Not charging,
temporary fault (e.g. too hot/cold).
Flashing blue - Not charging - Re-fit charger or try
another socket. If persists, contact Dyson Helpline.
Solid blue: Boost ‘ON’.
Light off: Powerful suction.
Flashing blue: Low battery warning.
Fast flashing blue: No power, temporary
fault (e.g. check filter or for blockages).

Related product manuals