Changing/fitting the belt
(steel/yellow model only)
11
E Use back of cleaner as lever,
loop belt around thumb. Turn the
belt 90 degrees, stretch and
release over spindle.Belt must be
free of twists as shown.
F Rest the three tabs on inside of
yellow bumper strip and secure
soleplate back into position.
G Ensure soleplate is in correct
position before use.
Optional: Mini turbine head
A Release catches and remove
the soleplate.
B Remove both brushbars and
clear away thread and hair.
C To reassemble, match the arrows
on the brushbar to the arrows on
central support.
D Align front of soleplate with front
of tool and secure all 3 catches.
E Ensure slider is set as shown.
Important information
Ensure soleplate is in correct
position before use.
A
B D
C
Optional: maintaining the Mini turbine head
E
E
F
G
To Next Page
Loading...
