Changing/fitting the belt
(steel/yellow model only)
10
Turn power off, unplug machine
and allow machine to cool for 1
hour before changing/fitting belt.
Ensure soleplate is in correct
position before use.
Remove wand and turn machine
upside down.
A Undo fasteners using a coin,
slide back end caps and remove
soleplate.
B Remove dirt or debris and check
spindle is clean.
C To replace the belt, remove the
brushbar, loop belt around
brushbar and feed through hole.
D Check end caps are in place.
Important information
A
B
C
D
To Next Page
Loading...
