service manual
Issued 10/06
22
Fitting notes
Refit the entry seal onto the duct assembly.
89
Refit the exhaust seal onto the duct assembly.
88
Locate the cyclone release catch spring
between the cyclone release catch and duct
assembly.
87
AAfftteerr aasssseemmbblliinngg tthhee ppaarrttss oonnttoo tthhee dduucctt
aasssseemmbbllyy,, tthhee ffoolllloowwiinngg ppaarrttss sshhoouulldd bbee
ffiitttteedd aass pprreevviioouussl
lyy sshhoowwnn::
Powercord and switch cover (pages 18 - 19)
Undercarriage assembly (page 16)
Yoke assembly (pages 13 - 14)
Motor assembly (pages 9 - 11)
Sub assemblies - cleaner head -
dismantle
Remove both halves of the brushbar assembly
from the brushbar motor assembly.
92
Twist the endcap assemblies off either side
of the brush housing.
91
Undo the endcap fasteners from either side
of the brush housing using a large flat bladed
screwdriver or coin.
90
To Next Page
Loading...
