service manual
Issued 10/06
37
Fitting notes
Sub-assemblies - bin assembly
The FDC seal can be removed from the
bottom of the cyclone assembly. When
refitting, align the locating tab with the recess.
Ensure that all retaining ribs are covered by the
seal.
172
Should it need replacing, the bin seal
simply pulls off the cyclone assembly. When
refitting, ensure the locating tab on the seal
aligns with the recess on the cyclone assembly.
171
To replace the bin base assembly, activate the
bin base release. Then pull the bin base away
from the bin until it ‘bumps’ off.
173
Locate one of the hinge points on the new
bin base assembly into the retainer on the bin.
Firmly press the other hinge point into place.
174
To Next Page
Loading...
