USING YOUR DYSON VACUUM
CAUTION:
safely.
liquids – electric shock or personal injury could occur.
immediately. The cord must only be replaced by Dyson or our appointed service
agents to avoid a hazard.
of the stairs. Keep the vacuum on the floor. Do not put the vacuum on chairs, tables
etc.
clear bin
TM
, filters, hose, checking for blockages or before performing any other
maintenance operation.
that shown in this Operating Manual, or as advised by the Dyson Helpline.
or immersed in liquid, contact the Dyson Helpline.
which can be found behind the clear bin
TM
. The vacuum must only be used as rated.
cause injury.
PLEASE NOTE:
and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating
brush bar is used when vacuuming. If this happens, we recommend vacuuming in bare
floors mode and consulting with your flooring manufacturer.
or stored outdoors. It should not be used for commercial or rental purposes.
Cleaning Kit accessories. If used in a garage, care should be taken to wipe the
soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt or
pebbles which could damage delicate floors.
because they may damage the vacuum.
TM
or wand. These are not associated with the electricity supply. To minimize any effect
from this, do not put your hand or insert any object into the clear bin
TM
unless you have
first emptied it and rinsed it out with cold water.
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Dyson Helpline.
EMPTYING THE CLEAR BIN
TM
CAUTION:
TM
and do not leave
unattended. The motor will operate with the clear bin
TM
off.
PLEASE NOTE:
TM
as soon as the MAX mark level is reached.
TM
electric shock or personal injury.
CLEANING THE CLEAR BIN
TM
CAUTION:
TM
is completely dry before re-fitting.
PLEASE NOTE:
TM
.
TM
in a dishwasher.
WASHING YOUR FILTERS
CAUTION:
PLEASE NOTE:
regularly and wash at least every three months according to instructions, to maintain
performance.
again to ensure all excess water is removed. This will normally require up to 10 rinse
cycles. Please leave to dry completely for 24 hours.
microwave or near an open flame.
CLEARING BLOCKAGES
CAUTION:
in electric shock or personal injury.
PLEASE NOTE:
overheats it will cut-out and it must then be switched off and unplugged immediately
and allowed to cool down before attempting to check filters or for blockages.
and remove the plug before removing the blockage. Do not operate the wand release
catch.
8