Dyson DC26 Helpline Manual

helpline manual
16
Loss of pick-up from the floor tool
Carry out these checks if the customer reports low suction or loss of pick-up from the floor tool.
For turbine tool variants carry out the ‘Turbine head brush bar not operating’ checks on page 19 if the brush bar is not spinning
before continuing with checks from this section.
Switch off and unplug the machine before carrying out these checks:
Check the bleed valve on the floor tool
for blockages or obstructions.
Switch machine ON and test suction
from the end of the extension tube. If
suction is weak continue with checks.
Switch machine OFF.
Press the release catch and remove the
hose.
2 3
5
4
9
8
7
Press the release catch and remove the
extension tube.
6
Press the release catch and remove the
floor tool.
1
Switch machine ON and test suction
from the end of the wand. If suction is
weak continue with checks, if strong
check the extension tube for blockages.
Switch machine ON and test suction
from the end of the hose. If suction is
weak continue with checks, if strong
check the wand handle for blockages
and check the suction release trigger.
Undo fasteners and remove the post
filter cover.
Debris channel
Bleed valve
Check the floor tool for blockages
or obstructions, paying particular
attention to the debris channel and the
underside of the bleed valve.

Dyson DC26 Specifications

General

Suction power	160 AW
Maximum input power	- W
Annual energy consumption	- kWh
Proper use	Home
Noise level	- dB
Removable filter	Yes
Cleaning surfaces	Carpet, Hard floor
Vacuum air filtering	HEPA
Dirt separating method	Filtering
Type	Cylinder vacuum
Cordless	No
Cleaning type	Dry
Dust capacity	- L
Product color	Blue, Transparent
Tube material	The material the tube is made of.
Dust container type	Bagless
Cord length	5 m
Dust capacity dry	0.68 L
Vacuum brushes included	Hard floor brush

Weight and Dimensions

Weight	5200 g