To Next PageTo Next Page
Need help?Do you have a question about the Dyson DC41C and is the answer not in the manual?
General| Brand | Dyson |
|---|---|
| Model | DC41C |
| Category | Vacuum Cleaner |
| Language | English |
Wash the filter with cold water only and ensure it is completely dry before replacing.
Carry the appliance by the main handle. Do not press the cyclone release button or shake.
Empty when dirt reaches MAX mark. Remove cyclone and clear bin unit.
Wash filter with cold water only. Allow at least 24 hours to dry completely.
Appliance may overheat and cut out if blocked. Follow blockage instructions.
Switch off and unplug. Allow to cool for 1-2 hours before checking for blockages.
If brush bar is obstructed, it may shut off. Remove brush bar to clear.
Empty when dirt reaches MAX. Remove cyclone/bin. Seal bag and dispose.
Wash filter with cold water. Squeeze out water. Dry completely for 24 hours.
Appliance cuts out if blocked/overheated. Follow blockage instructions.
Switch off, unplug. Wait 1-2 hours. Check for blockages carefully.
If brush stops, remove and clear obstructions. Use coin to loosen fastener.
