Washing your brush bar
To maintain optimum performance, check and wash the brush bar regularly.
Remove brush bar
2
1
Don’t put any part of your machine in a dishwasher or use detergents, polishes
or air fresheners.
Press the cleaner head release button to remove it from the wand.
Pull the brush bar off the end cap and put the end cap to one side, don’t wash it.
Wash and dry brush bar
Hold your brush bar under cold tap water and gently rub to remove any lint
or dirt. Keep washing until the water runs clear.
Stand the brush bar upright and leave for at least 24 hours to dry.
Replace your brush bars
3
1
2
Make sure your brush bar is completely dry before refitting.
Reattach the end cap to the brush bar and slide it back into the cleaner head.
Rotate the end cap until it clips securely back into position.
The cleaner head housing is not washable and should only be wiped over
with a damp lint-free cloth.
The brush bar
reinserted into the
cleaner head and the
end cap rotated to
the locked position.
The end cap should be
attached to the cleaner
head at an angle less
than 90°, any angle
greater than this will
not allow the end cap
to close.
The brush bar has an open
end and a closed end. Stand
upright, with the closed end
facing upwards, to dry.
The end cap is located
at the side of the
cleaner head. Push
this upwards to unlock
the brush bar. Don’t
wash the end cap.
To Next Page
Loading...
Need help?
General
