Emptying your bin
Empty as soon as the dirt reaches the MAX level – don’t overfill. Using your
machine when the dirt is above the MAX line may affect the performance
and require more frequent filter washing.
Remove your wand
Press the red wand release button, on the top of the wand, and pull the
wand away from the bin.
Release the dirt
Hold the machine over the bin, pointing downwards.
Firmly push the red bin release button. The bin will slide down, cleaning the shroud
as it goes, and the bin base will open.
The bin base won’t open if the red bin release button isn’t pushed down all the way.
Minimise dust contact
Cover your bin tightly in a dust proof bag while you empty. Remove the bin
carefully, seal the bag tightly and dispose.
Close your bin
Push the bin base upwards until the bin and bin base click into place.
Cleaning your bin
Remove your bin
If it is necessary to clean your bin, empty it as shown in the ‘Emptying your bin’ section.
Press the red button located on the bin runner to release the bin and slide your bin off the runner.
Only clean your bin with a damp cloth.
Make sure that the bin and seals are completely dry before replacing.
Refit your bin
Insert the spine on to the bin runner.
Close your bin by pushing the bin base upwards until the bin and bin base click into place.
Your bin isn’t dishwasher safe and the use of detergents, polishes or air fresheners to clean your
bin isn’t recommended, as it may damage your machine.
The MAX mark on the bin of
the machine, showing that
the dirt should not be filled
over the Max mark when the
machine is at the angle of
normal use.
The bin lid closing with
an audible click and
the bin being pushed
upwards with another
click once it is fully
inplace.
Illustration of the bin being
emptied into a bag with
images demonstrating to take
care not to press the trigger
when emptying the bin.
Two images of the bin with
arrows showing the bin lid
closing and a click symbol
and the bin being pushed
upwards with another click
symbol.
The bin being removed
and the location of the
bin release lever on the
underside of the bin
runner.
The bin being pushed
back into position on
the bin runner.