35
Sleep timer Tilt function
Oscillation and airflow speed control
Diffused and focused modes
Diffused mode
Press the wide angle button to
change from a personal directed
airflow to wider projection of air flow.
Oscillation control
To start the machine oscillating, press
the oscillation control button. To
stop the machine oscillating, press it
again. The machine will not oscillate
when the control buttons are pressed.
Focused mode
Press the narrow angle button to
change from a wider projection of
airflow to a personal directed airflow.
Airflow speed control
To change the airflow speed press
the airflow control button. The digital
display will show the new fan speed.
If in heating mode, after 2.5 seconds
it will change back to displaying the
target temperature.
To set the sleep timer, press and hold the timer button to select the
desired time. When time reaches zero, the machine will go into
standby mode. To cancel, reduce the time until two dashes appear.
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
Heating and cooling modes work
in this mode.
Heating and cooling modes work
in this mode.
To Next Page
Loading...
