Dyson Hot+Cool AM09 - Remote Control; Heating and Cooling Modes

34

Power
Remote control
Heating and cooling modes
Remote control docks magnetically.
Attach the remote control to the top of the
machine with the buttons facing down.
Each time the heating mode is selected, it conducts a short
calibration cycle. Airflow will be automatically controlled
during this cycle. Once the calibration cycle is complete, it
will revert to the selected airflow speed.
Cooling mode
Press the blue cooling mode button to enter cooling mode.
The power button light will change from red to blue to
indicate that you have entered cooling mode. To adjust the
airflow speed use the airflow control button.
To operate, point the
remote control toward the
front of the base.
Standby
ON/OFF
Cooling mode
Airflow speed
control
Thermostat
control
Sleep timer
Oscillation
ON/OFF
Focused
mode
Diffused mode
Press and hold the power
button to run through the
target temperatures.
On first use, the machine will default to a temperature 3°C
higher than the detected room temperature. Thereafter, the
machine will remember the last target temperature set.
Select the desired room temperature.
Pressing the large red button increases
the target temperature by 1°C; the
smaller red button decreases it by 1°C.
The machine will not operate in heater
mode unless the target temperature is
above the room temperature.
Heating mode
Press the red thermostat control button until the digital display shows the
target room temperature. The power button light will change from blue
to red to indicate that you have entered heating mode. The red circle will
disappear when the target room temperature is reached. Once the target
room temperature has been reached, the machine will stop heating the
air. If the room temperature falls below the target room temperature, the
machine will start to heat again.