5
and can lead to death in as little
as 2 hours. Always completely
secure the battery compartment.
If the battery compartment does
not close securely, stop using the
product, remove the batteries,
and keep it away from children.
If you think batteries might
have been swallowed or placed
inside any part of the body, seek
immediate medical attention.
READ AND SAVE
THESE INSTRUCTIONS
Additional information
Maintaining your machine
• To always get the best performance from your machine, it's
important to regularly clean it and check for blockages.
Cleaning your machine
• If dust accumulates on the surface of your machine, wipe dust
from the loop amplifier, shrouds and other parts with a clean, dry
cloth only.
• Look for blockages in the air inlet holes on the shroud and the small
aperture inside the loop amplifier.
• Use a soft brush to remove dust and debris.
• Don't use detergents or polishes to clean your machine.
Replaceable parts
• Your machine has replaceable filter units and batteries,
any other servicing must be carried out by an authorised
service representative.
Battery replacement
Caution
• Unscrew the battery compartment on the remote control. Loosen the
base and pull to remove the battery.
• Do not install backwards or short circuit the batteries.
• Do not attempt to dismantle or charge the batteries. Keep away
from fire.
• Follow battery manufacturers' instructions when installing new
batteries (battery type CR 2032).
• Always replace the screw in the remote control and refer to the
battery hazard in the warning section.
Non-washable filter units
• Your filter units are non-washable and non-recyclable.
• Failure to replace the filter units when prompted may result in
changes to product performance and appearance.
• Replacement filter units can be purchased at www.dyson.com
Auto mode
• A period of six days is required after your machine is first used for
the sensor to calibrate. During this period your machine may be
more sensitive to VOCs (such as odours) than normal.
• During first use, whilst the sensors calibrate, your machine can take
up to two minutes to show VOC and NO
2
data.
Automatic cut-out
• For your safety, your machine is fitted with automatic cut-out
switches that operate if the machine tips over or overheats. If the
switches operate, unplug your machine and allow it to cool. Before
restarting your machine, check and clear any blockages and ensure
your machine is on a solid level surface.
• In heating mode, your machine will automatically switch off after
nine hours of continuous use. To restart your machine, press the
Standby on/off button on the remote control or the base.
Disposal information
• Dyson products are made from high grade recyclable materials.
Recycle where possible.
• Dispose of or recycle the battery in accordance with local
ordinances or regulations.
To Next Page
Loading...
