Replace your brush bar
Remove your brush bar
Wash and dry your brush bar
Don’t put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Press the cleaner head release button on the end of the wand. Place the
cleaner head upside down.
Push the end cap up fully and pull the brush bar out of the cleaner head.
Remove the end cap from the brush bar. Don't wash the end cap.
Slide your brush bar out of the cleaner head.
Hold your brush bar under running water and gently rub to remove any lint
or dirt.
Stand your brush bar upright as shown. Leave to dry completely for at least
24 hours.
Before replacing, check that your brush bar is completely dry.
Reattach the end cap to your brush bar.
Slide your brush bar into the cleaner head. Push the end cap back down to
the closed position.
To maintain optimum performance, keep your laser lens clean. Only clean
the lens when the cleaner head is not attached to your machine.
Use a soft, dry, lint-free cloth to wipe the lens.
2
1
Cleaning your laser lens
Washing your Laser Slim Fluffy
TM
cleaner head brush bar
Your Laser Slim Fluffy
TM
cleaner head has a washable brush bar. To maintain
optimum performance, check and wash your brush bar regularly.
Make sure your machine is disconnected from the charger and take
care not to touch the trigger.
3
1
2
The end cap should
be attached to the
cleaner head at an
angle less than 90°,
any angle greater
than this will not allow
the end cap to close.
The end cap is
located at the side
of the cleaner head.
Push this upwards to
unlock the brush bar.
Don't wash the end
cap.
The brush bar has
an open end and a
closed end. Stand
upright, with the
closed end facing
upwards, to dry.
To Next Page
Loading...
Need help?
General
