Dyson Outsize User Manual

Replace your brush bar
Your Digital Motorbar
TM
XL cleaner head doesn't have a washable brush bar.
To maintain optimum performance, check your brush bar regularly and clear
any obstructions.
Make sure your machine is disconnected from the charger and take care not
to touch the trigger.
Clearing obstructions from your
Digital Motorbar
TM
XL cleaner head
Remove your brush bar
Look for obstructions
Don’t put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Press the cleaner head release button on the end of the wand.
Place the cleaner head upside down.
Lift the catch on the cleaner head to release the brush bar.
Slide your brush bar out of the cleaner head.
Push the brush bar back into the cleaner head.
Push down the brush bar release catch until it locks in position.
Clear any debris from your brush bar.
Check inside the cleaner head and remove any debris or blockages.
Your Digital Motorbar
TM
XL cleaner head and brush bar aren't washable.
Wipe over with a damp lint-free cloth.
The brush bar release is
located on the back of the
cleaner head on the left hand
side. The brush bar pulls out
of the opposite end of the
cleaner head.

Dyson Outsize Specifications

General

Suction Power	220 AW
Filtration	Whole-machine HEPA filtration
Cleaner Head	Laser Slim Fluffy cleaner head, High Torque cleaner head
Charge Time	4.5 hours
Warranty	2 years
Type	Cordless
Run Time	60 minutes
Accessories	Combination tool, Crevice tool, Docking station