7
To set the sleep timer, select the desired time. When time
reaches zero, the machine will go into standby mode. To
cancel, increase the time until two dashes appear.
When using the sleep timer, the LED display will turn off
after 10 seconds of inactivity.
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
Diffused and focused modes
Tilt functionSleep timer
Oscillation and airflow speed control
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to a whole
room airflow.
Focused mode
Press the narrow angle button to
change from a whole room airflow
to a personal directed airflow.
Oscillation control
To start the machine oscillating,
press the oscillation control
button. To stop the machine
oscillating, press it again. The
machine will not oscillate when
the control buttons are pressed.
Airflow speed control
To change the airflow speed
press the airflow control button.
The digital display will show
the new speed; after 3 seconds
it will change back to the
target temperature.
Heating and cooling modes
work in this mode.
Heating and cooling modes
work in this mode.
To Next Page
Loading...
