6
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle is
complete, it will revert to the selected airflow speed.
On first use, the machine will default to a temperature
3°C higher than the detected room temperature.
Thereafter, the machine will remember the last target
temperature set.
Select the desired room temperature. Pressing the
large red button increases the target temperature by
1°C; the smaller red button decreases it by 1°C. The
machine will not operate in heating mode unless the
target temperature is above the room temperature.
Press and hold the power button to run through the
target temperatures.
Press the red thermostat control button until the digital display
shows the target room temperature. The power button light will change
from blue to red to indicate that you have entered heating mode. The
red circle will disappear when the target room temperature is reached.
Once the target room temperature has been reached, the machine will
stop heating the air. If the room temperature falls below the target room
temperature, the machine will start to heat again.
Press the blue cool mode button to enter cool mode.
The power button light will change from red to blue to indicate that
you have entered cool mode. To adjust the airflow speed use the
airflow control button.
To operate, point the
remote control toward
the front of the base.
Power
Remote control
Airflow speed control
Remote control docks magnetically.
Attach the remote control to the top of the
machine with the buttons facing down.
Standby
ON/OFF
Airflow
control
Sleep timer
Focused
mode
Oscillation
ON/OFF
Diffused mode
Thermostat
control
Cooling
mode
To Next Page
Loading...
