3
Clik
Clik
Assembling your machine
Your Dyson purifying humidifying fan comes
with a Combination filter.
Remove the Combination filter from any protective
packaging.
Push both the Combination filters into the
shrouds until the tabs on the top and bottom
click into place.
Put the shrouds into position on the main body
and push gently until they click securely into place.
Your Dyson purifying humidifying fan comes
with a permanent Dyson Cryptomic
TM
filter and
a Combination filter.
Remove the Combination and Dyson Cryptomic
TM
filters from any protective packaging.
Push the Dyson Cryptomic
TM
filter into position
on the inner door.
Push both Combination filters into the
shrouds until the tabs on the top and bottom
click into place.
Place the remote control on top of the machine
with the buttons facing down.
Plug in and switch on.
Put the shrouds into position on the main body
and push gently until they click securely into place.
Place the remote control on top of the machine
with the buttons facing down.
Plug in and switch on.
Use both hands to lift your Dyson purifying
humidifying fan out of the box, by its base.
Don’t lift it out by the amplifier loop.
Push down the Shroud release buttons on both
sides of your machine to release the shrouds.
As the shrouds are removed, the inner door
housing the evaporator will spring open.
Close the inner door, making sure it clicks
firmly shut.
Use both hands to lift your Dyson purifying
humidifying fan out of the box, by its base.
Don’t lift it out by the amplifier loop.
Push down the Shroud release buttons on both
sides of your machine to release the shrouds.
As the shrouds are removed, the inner door
housing the evaporator will spring open.
Close the inner door, making sure it clicks
firmly shut.
To Next Page
Loading...
Need help?
General
