Airflow control
Capsule
Scalp protect mode on/off
Temperature control
Power on/off
Cold shot
3 precise settings:
- Fast/High
- Gentle/Medium
- Mild/Low
Home to the
Time of Flight sensor,
Hall sensor and
Capsule illumination.
Scalp care is activated
by default on first use.
4 precise heat settings.
Sliding switch.
Press and hold to
deactivate heat
and set style.
Air inlet
Removable filter cage
Easy to remove for cleaning.
Getting started
LEDs
The air inlet is covered
by the filter and is at the
bottom of the handle.
The filter cage is at the
bottom of the handle.
The power button
is on the back, at
the top of the handle.
It is a slider button
that pushes upwards
or downwards.
The Cold shot button is
on the back of the
handle of the hair
dryer, just below
the power button.
The temperature
control button is on
the back right-hand
side of the cylindrical
head of the hair dryer.
The airflow control
button is on the back
left-hand side of
the cylindrical head
of the hair dryer.
The capsule is
suspended in the
middle of the hair
dryer's central bore.
The Scalp protect button
is on the back, at the top
of the cylindrical head
of the hair dryer.
The LED lights are on
the back of the
cylindrical head of the
hair dryer. They are
above the airflow and
temperature buttons.
There are three LED
lights on each side,
which light up as the
corresponding button
is pressed. These lights
also indicate when your
filter needs cleaning
or if there is a fault.
View of the back of the Dyson Supersonic Nural hair dryer
showing the airflow button with LED lights on the left, the
temperature button with LEDs on the right, and the Scalp
protect button at the top. The power button and cold shot
buttons are below, on the handle.
To Next Page
Loading...
