8
Clean the hatch every time the filter is
replaced. Open the small hatch on the side
of the machine. Use a cotton swab to clean
inside and remove any debris. This maintains
sensor accuracy and ensures the continuing
high performance of the machine.
Look for blockages in the small aperture inside the loop amplifier.
Use a soft brush to remove debris.
Ensure that the machine is unplugged. Dust may
accumulate on the surface of the machine.
Wipe dust from the loop amplifier, filter unit
and other parts with a dry or damp cloth
when dust accumulates.
Press buttons to lift off loop amplifier and lift off filter.
Ensure that the machine is unplugged. Look for blockages in the
air inlet holes on the filter. Use a soft brush to remove debris.
Look for blockages in the air inlet holes under the filter and use a soft
brush to remove debris. Replace the filter and then the loop amplifier.
Do not use detergents or polishes
to clean the machine.
Clearing blockages
Cleaning
To Next Page
Loading...
Need help?
General
