3-4.5hrs
7
Emptying your clear bin
Charging and storing
your machine
Connect to the charger either directly or in
the docking station.
The blue LEDs on either side of the battery
will flash during charging.
When the battery is charged, both LEDs will
light for 5 seconds.
Changing your battery
To remove a battery
Hold your hand under the
battery to support it.
Press the battery release
button and slide the battery
off the handle.
Place the battery on charge.
Where you have additional batteries, we recommend that you
alternate the batteries to maintain even performance.
It's important to fully charge your new machine before using it for the first time,
and after every clean. This is because the battery and monitoring system's
algorithm 'learns' over time, and fully charging your machine helps it to more
accurately calculate and display remaining run time.
To install a battery
Slide the battery onto the
handle until it clicks securely
in place.
Your battery is fully
charged when the
display shows 100%.
Your machine won't
operate if the ambient
temperature is below
0°C (32°F). This is
designed to protect
both the motor and
battery.
Battery empty and
needs charging.
clik
2
1
34
Be careful not to pull
the power trigger while
the clear bin is open
for emptying.
To close the clear bin, push the bin base upwards
until the clear bin and bin base click into place.
clik