There are two kinds of installation: covert and non covert.
4.3.1 If you need the covert installation, please refer
installation to an auto electrical contractor.
Note:
1) To prevent theft of the tracker, please install it as
covertly as possible.
2) Avoid placing the tracker close to higher power
electrical devices, such as reversing radar, anti-theft
device or other vehicle communication equipment.
3) The tracker should be fixed into position with cable
ties or wide double-side tape.
4) During installation, please make sure the receiving
side face is up, with no metal object above the device
to interfere with GPS reception. The following places
are suggested for installation:
Figure 5 installation place suggested
Under the dash board below the front windshield;
- In the parcel shelf in the rear;
- In the front bumper (non-material face), please ensure the
device cannot get wet;
- Under the wiper version (non-metal), please ensure the
device cannot get wet.
Notice: If the windshield is pasted with metal thermal-
protective coating, it may affect the performance of the
device. In this case, please change the installation place after
To Next Page
Loading...
