- 7 -
Setting the Time
Setting the time when switching on
for the first time:
➩ Keep the button TIME
r
pressed
down to change into the 12h or 24h
modus.
➩ The time display flashes. Using the
buttons MINUTE and HOUR
w
enter
in the correct time.
➩ When you re-press the TIME
r
, the
adjustment is saved. The time display
no longer flashes.
Setting the time at some later point:
➩ Keep the button TIME
r
pressed
down to change into the 12h or 24h
modus.
➩ Press the button TIME
r
.
The time
display flashes. Using the buttons
MINUTE and HOUR
w
enter in the
time setting required.
➩ When you re-press the button TIME
r
, the adjustment is saved. The time
display no longer flashes.
Radio operation
1. Adjust the function selector switch
2&
to the position TUNER.
2. Adjust the function selector switch
2#
to the position FM (VHF) or AM (MW).
3. To optimise reception, extend the FM
Antenna
2%
to its full length. For the
AM waveband, the appliance needs
to be fine-tuned to achieve optimum
reception.
4. Switch the appliance on with the
power button (ON/OFF)
u
. The LED
display
f
glows when the appliance
is switched on.
5. Adjust the desired sound volume
level with the volume controller
2$
.
6. Tune in to the desired radio station
with the TUNING controller
2@
.
Should a programme be transmitted
in stereo and the appliance is set for
stereo reception, the LED display FM
STEREO
o
glows. For this, the button
FM Stereo/Mono
2^
must be set to
the position FM Stereo.
7. To switch the radio off, press the
power button ON/OFF
u
. The LED
power display extinguishes.
Use of the CD Player
1. Open the CD compartment
q
in that
you press the button OPEN
e
, then
place a CD (label upwards) into the
CD compartment.
2. Adjust the function selector switch
2&
to the CD-Position.
3. After pressing the power button
ON/OFF
u
the total number of titles
on the CD is shown in the display
i
.
After a brief moment, the time is
displayed again.
4. Press the button PLAY/PAUSE
2)
, to
start playback of the first title. In the
Display
i
first appears , shortly
thereafter the time is however once
again displayed.
You can also use the button PLAY/
PAUSE
2)
to temporarily interrupt
the playback of a title. Playback is
continued by once again pressing
the button PLAY/PAUSE
2)
.
01
To Next Page
Loading...
