300/302 Owner’s Manual
22
302 BOOST LEVEL SETUP
If stimulation level is 10, boosted stimulation sends [10 + boost level ]
The default value of the boosted level is 5, it can be adjusted to any
value between 1 and 60.
Determining the Boosted stimulation level is a little more difficult than
stimulation level setting due to the wide differences in temperaments
and stimulation tolerance among the many breeds of dogs. On
average, it is normally 5 to 20 levels higher than the “Conditioning”
level.
How to Setup Boost Level for Dog 1 (Black Collar Dog)
1. Change the mode to Momentary Mode
(Press M/C button until “M” is displayed)
2. Change the intensity level to “0”
3. Press S(Black) button for more than 5 seconds
4. The intensity level will change 0 to 1 and start to blink.
5. Rotate the dial to change the boost level (up to 60).
6. Press S(Black) button again to save and exit from
Boost Level Change Mode. If any other button is pressed or is idle
for 20 sec, Boost Level Change Mode will be cancelled.
If you want to change boost level for Dog 2 (Red Collar Dog),
Press S(Red) instead of black on step #3, and #6
To Next Page
Loading...
