E/D/E HLT1-520 - User Manual

Questions and Answers

C
Courtney WarrenAug 11, 2025
Why E/D/E Lifting Systems fork cannot be pumped up?
- M
  Miguel FordAug 11, 2025
  There are several reasons why the fork of your E/D/E Lifting System might not be pumping up. It could be due to a low oil level in the oil tank, which requires adding the proper hydraulic oil. Alternatively, there might be air in the hydraulic system; try operating the handle rapidly several times to bleed the system. Lastly, the pendulum arm nut may not be adjusted correctly; in this case, adjust the pendulum arm screw.
J
Jennifer MullinsAug 19, 2025
What to do if E/D/E HLT1-520 fork can’t be released down?
- D
  David WoodAug 19, 2025
  If the fork of your E/D/E Lifting System is stuck and can't be released down, the issue might be that the fork is blocked. Check for and remove any obstructions. Another possibility is that the pendulum arm nut isn't adjusted properly; in that case, adjust the pendulum arm nut correctly.
E
Emily KelleyAug 27, 2025
Why E/D/E HLT1-520 Lifting Systems fork can’t be pumped up to rated highest position?
- M
  Matthew YoungAug 27, 2025
  If the fork of your E/D/E Lifting System isn't reaching its rated highest position when pumped up, it could be due to insufficient oil. Add hydraulic oil to resolve this issue.
A
adamjonesSep 2, 2025
What to do if neutral has no difference between position I and position II of release lever in E/D/E HLT1-520?
- T
  Tracy ConwaySep 2, 2025
  If you notice no difference in neutral between positions I and II of the release lever on your E/D/E Lifting System, the pendulum arm nut may not be adjusted properly. Adjust the pendulum arm nut to correct this.

E/D/E HLT1-520 Specifications

General

Brand	E/D/E
Model	HLT1-520
Category	Lifting Systems
Language	English

E/D/E HLT1-520 - User Manual

Table of Contents

Questions and Answers

E/D/E HLT1-520 Specifications