Flat Foamy Profile Jet
Weight w/Battery: 2.0 oz
Prop: 3 x 4 Slow Flyer
Battery: 250mAh 2-Cell 7.4V Li-Po
ESC: 10A Brushless
Comments – Extreme speed for fantastic indoor performance.
Accessories and Spare Parts:
See our web site at
www.E-fliteRC.com or www.horizonhobby.com for our complete line of brushless motors. We
have posted a specification comparison sheet on our web site so you can compare the different motors we offer.
EFLA110 Power Meter (measures power output in amps, volts, watts, and capacity)
EFLA1010 10A Pro Brushless ESC
EFLA248 Bullet Connector Set, Gold, 2mm (3)
EFLM1121 Replacement Mount: Park 180
EFLM1933 Prop Adapter with Setscrew, 1.5mm
EFLM1962 Carbon Fiber Tube, 6”, 7mm OD, 5mm ID: Park 180
Operating Instructions:
1. This brushless motor requires the use of a sensorless brushless speed control. Failure to use the correct
speed control may result in damage to the motor and/or speed control.
2. When mounting the motor, be sure the correct length of screws are used so damage to the inside of the motor
will not occur. We suggest you use the mounting hardware included with your motor. The use of long screws
will damage the motor.
3. You may connect the three motor wires directly to the controller with solder or use connectors such as gold
plated brushless bullet connectors (EFLA248), which will also need to be soldered properly to your wires. The
three motor wires can be connected in any order to the three output wires or output port on a sensorless
brushless speed control. Be sure to use heat shrink tubing to properly insulate the wires so the wires will not
short. Shorting may damage the motor and speed control.
4. If you add connectors and or you no longer wish to use them, never cut the motor wires. Remove them by
properly de-soldering them. Shortening the motor wires is considered an improper modification of the motor
and may cause the motor to fail.
5. When you connect the motor to the esc, check the rotation direction of the motor. If you find the rotation is
reversed, switching any two motor wires will reverse the direction so the motor rotates properly.
6. Proper cooling of the motor is very important during operation. New technology has brought much higher
capacity batteries with higher discharge rates, which can cause extreme motor temperatures during operation.
It is the responsibility of the user to monitor the temperature and prevent overheating. Overheating of the
motor is not covered under any warranty.
7. You can install the propeller on the motor shaft after you have confirmed proper rotation direction. Also
consult the instruction included with your sensorless electronic speed control for proper adjustments and
timing.
8. Once the battery is connected to the motor, please use extreme caution. Stay clear of the propeller during
operation. Spinning propellers are very dangerous as the motors produce high amounts of torque.
9. Never disassemble the motor. This will void any warranty.
Installation:
NOTE: Photo shows installation of x-mount onto the motor.
To Next Page
Loading...
