DISC BRAKE ADJUSTMENT ADJUSTING STEERER TUBE WOBBLE
If the disc is rubbing against the brake pads, use a M5 hex wrench to undo the
cable holder on the caliper. Gently reduce the amount of cable feeding into the
caliper until there is no more rubbing. Tighten the cable holder to secure. If the
pads are not gripping the disc enough, repeat the process and increase the cable
feed into the caliper.
If the steerer tube wobbles during riding, the locks on the clamp need to be
tightened to secure it.
8 9
To Next Page
Loading...
